Home   Products   Back to G2 Line   Site Map   

The G2 comes equipped with an electric actuator for raising and lowering the tooth bar on the fly. If you get the optional TrackSetter, it also comes with an electric actuator. The actuators come standard with male and female spade connectors for its two wires. G2 machines have wiring guides along the frame, ready to accept customer supplied power and wiring for the actuators.

A two wire, 12 volt, 25 amp, circuit is required for each actuator. The current is simply reversed to control the actuator up/down movement. Most customers will place a double pole momentary toggle switch on the dash of the tow vehicle for each actuator on the machine (again, 1 for the G2 Toothbar, and 1 for each Tracksetter). Many customers use the tow vehicle battery to supply power (operating actuators is very sporadic, so draining down a battery is seldom a concern). Some customers prefer to use a separate rechargeable power pack to avoid relying on sometimes unpredictable snow machine electrical systems. Check out our optional Wiring Kit by clicking here.

Back to Top

   Home   Products   Back to G2 Line   Site Map