CC Tracksetter

OPERATION AND DOWN PRESSURE

The G2 tracksetter is close-coupled and semi-rigidly attached to the rear of the compaction bed. An electric actuator applies up to 200 lbs. of down pressure through two constant-pressure gas-filled cylinders. Because of the G2 tracksetter’s unique attachment design, this down pressure is applied much more effectively than conventional designs that let the tracksetter float on a center pivot. The stability and efficient application of down pressure allow the G2 to set track at much higher speeds than a conventional machine.

Click on Picture to View an Animation of the Operation and Down Pressure

Back to Top

POSITIONING

The Tracksetter is easily positioned anywhere across the width of the G2 without tools. Two tracksetters may be used on the Medium G2 to enable setting tracks on either side without leaving the seat of the snowmachine, or setting a well spaced pair of side by side classic tracks.

Click on picture to view an animation of the positioning of the G2 Tracksetter. The tracksetter position is adjusted without tools by simply loosening a handwheel and sliding the tracksetter on the toolbar.

Back to Top

TRACK CUTTERS

The track cutter is a pair of 45 deg. angled teeth which are highly resistant to collecting debris, yet provide good protection for the track shoes in low snow conditions. These are the same inexpensive and easily replaceable teeth used on the main toothbar.

Click for a larger view of the Track Cutter

Back to Top